Reliant Octel 200 and Octel 300 Message Servers PB6001401 User Manual
Page 633

Procedures 12-69
Octel Overture 200/300 Serenade 3.0
PB60014–01
The Octel Overture 200/300 responds with the following:
– – – – – – – SYSTEM INSTALLATION DIALOG – – – – – – – –
DAY MM/DD
HH:MM:SS
YYYY
ID:000
SN:000000 PBX:00
NEW CONFIGURATION INSTALLATION.
CLEARING ALL TABLES. . . DONE.
INITIALIZING ALL USER DIRECTORIES . . .
NOTE: Message Waiting setup 8:00 AM to 18:00 PM because
defaults were 0.
DONE.
The Octel Overture 200/300 then gives the following messages to indicate
the status of the reinstall. Answer the questions. Refer to Configuration
volume, INSTALL chapter.
Do you wish to PRE–LOAD any table from a previous INSTALL
from your DISKETTE? ( Y/N, empty line = N )
:Y
Insert desired DISKETTE in drive
.
Press RETURN when ready
...
PRE-LOAD ALL configuration tables?
:Y
Next, the Octel Overture 200/300 prompts you to insert the diskette.
When the pre-load is complete, the following message is printed:
TABLE PRE–LOAD COMPLETE
Do
you wish to set the system DATE and TIME?(Y/N,empty line = N)
Reinstall the Configuration
36. After the Octel Overture
200/300 has booted from the
hard disk, insert the
configuration backup diskette
into the FD.
37.
@INSTA
Enter