Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 322)

7-28 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
.
Press Escape to cancel LOG MF CDR at any time before the message server displays the LOG
FILTERS MODIFIED message. No changes are made to the CDR log.
- To disable transaction and status values from the CDR log, use the same command, LOG MF CDR .
The same procedure is used to disable transactions and status values, but after LOG MF CDR , enter
D before specifying the filters to modify.
@LOG MF CDR
Specify Filters to MODIFY:
<”E”nable or ”D”isable>
Empty line when done. ESCape to abort.
>D ALL ALL
>
LOG FILTERS MODIFIED
Displaying CDR Type and Status Configuration
The transaction types and status values, both those enabled and disabled, that are modified by the LOG
MF CDR command can be printed with the LOG PF CDR command.
- To print a single transaction type or all transaction types currently being collected in the CDR log
file, at the @ prompt, type
LOG PF CDR Enter
@LOG PF CDR
Specify Filters to PRINT:
<”E”nable or ”D”isable>
Empty line when done. ESCape to abort.
>
The message server prompts you to enter the filters that should be printed.
- To print specific information, enter a transaction type and status value at the > prompt. A transaction
type and a status value can be partially specified. When only the first letter (or two) is entered, all
types and values beginning with the letter are displayed. For example, if the status Fxxx should be
displayed for all transaction types that begin with
CAL , at the > prompt, type
E CAL F
Those transaction types beginning with
CAL , such as CALATD , CALATT , CALDID , that have a status
beginning with the letter F , such as FLLQ , FLUD , FLND , are printed.
- If all transaction types and all status values that are enabled are to be displayed, at the > prompt, type
E ALL ALL Enter