Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 253)

Maintenance Commands 6-23
Octel Overture 200/300 Serenade 3.0 PB60014–01
If the LIST NET command is followed by digits from the uniform numbering plan of a domain, the
messages pending for all domain network locations are listed. For example, the command LIST NET 4 ,
where the digit 4 is the first digit in the uniform numbering plan, gives exactly the same listing as LIST
NET DOMAIN in the preceding example.
You can list information about a specific domain location, rather than all domain locations, by adding the
location name after the
D in the LIST NET D command, as follows:
@L NET D DALLAS
LOCATION FRAME NUMBER: 0004
DELAY: 00002 MIN.
ERRORS: 00000
LIMIT: 00001
MESSAGE #
2001
LAN Status
Use the LANSTAT command to provide basic information about the current status of the LAN card,
digital networking and the Gateway Link. Information about the status of the LAN for previous periods in
the Network Traffic Report for Digital Networks and the Digital Network Performance Report. For
information about those reports, refer to the Reports chapter, Network Reports section, in this volume.
Use the LANSTAT command for information about the current status, whether the LAN is UP or DOWN
and the state of the high-speed links.
The following example shows that the LAN is up and running:
@LANSTAT
LAN STATUS: UP
LAST INITIALIZED ON 05/25/97 AT 06:05 PM
DIGITAL NETWORKING STATUS: UP
–––––––– HIGH–SPEED–LINK STATUS ––––––––––––––––
LOCATION
STATUS LAN–PRTCL OTHER
––––––––––––––––––––––––––––––––––––––––––––––––
SELF
– 3
CHCGO UP 2
NEWYRK DOWN –
DALLAS DOWN 1 OEM–FAIL
SFO UP 3
––––––––––––––––––––––––––––––––––––––––––––––––
GWL STATUS: DOWN – GATEWAY LINK SYSTEM PARAMETER IS NOT ENABLED
@
The entry in the LAN STATUS field is always UP , INITIALIZING , or DOWN .
The LAN card is running, with CPU communication to the card. The LAN is
running normally. If a Courtesy Down is in progress, the message
COURTESY
DOWN IN PROGRESS is shown.
When the LAN status is UP , the high-speed link status is given for each high-speed
digital location, as follows:
LAN Status