Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 358)

7A-6 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Table 7A-2 EVENT and AUX Activities in Call Process Trace Log (continued)
TYPE
Column
Entry
DESCRIPTION
AUX
Column
Entry
DESCRIPTION
EVENT
Column
Entry
FAX_MSG END_PLAY
(continued)
10
11
12
13
14
15
16
17
18
19
Transmitter failed in HDLC test. Used in
fax loopback test. Hardware error 63 is
logged
Receiver failed in HDLC test. Used in fax
loopback test. Hardware error 63 logged
Both transmitter and receiver failed in
HDLC test. Used in fax loopback test.
Hardware error 63 logged
Timeout occurred in HDLC test. Used in
fax loopback test. Hardware error 63
logged
No identification frame record from
remote fax
Remote fax did not respond to command
Unable to configure remote fax
Remote fax did not confirm Octel
Overture 200/300’s transmission fax
parameters
Hardware training failed. No carrier
No response from RX for multipage
signal
1A
1B
1C
1D
1E
1F
20
Unexpected frame from remote fax
No response from remote fax to end of
procedure frame
No response from remote fax to end of
message frame
No response from remote fax to
identification frame
Failure in receiving command frame from
remote fax
Remote fax failed in retransmitting bad
page and disconnected
Remote fax disconnected because of
resolution mismatch
END_RECRD Stop recording message. The CPT shows result codes for fax transactions in the AUX
column. For fax messages, the AUX column is empty if the
fax was successful. The most common result codes listed are
for the
END_PLAY event.
EX_AB_GRT Extended absence greeting. ON
OFF
FAX_CHAN FAX_CONCT Fax connect information.
FAX_CHAN FAX_INFO Fax message information.
FAX_CHAN FAX_DELIV Fax delivery. START
SUCCESS
FAIL
RETRY
Fax delivery failed, but will retry.
LAN FAXDLV Indicates the delivery and receipt of a fax
message at the receive and send sides.
.
The SOURCE column contains the
creator mailbox.
HAS_EXTN
NO_EXTN
This is the last message of a chain.