Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 609)

Procedures 12-45
Octel Overture 200/300 Serenade 3.0 PB60014–01
Hard Disk Add
This section provides the procedures to follow when adding a drive to a message server. Adding a drive to a
message server is usually done to increase system storage or to add the optional redundancy feature.
Action Octel Overture 200/300 Description and Response
The following message is printed.
CPU Model 300–6039–001 Rev 02F
486 Step 27 12MB
Testing Processor...PASSED
.
.
.
–––––– SYSTEM SOFTWARE RELEASE S.X.X.X (XX/XX/XX) ––––––
Copyright(c)
199X Octel Communications Corp
.
All Rights Reserved.
TUE 11/08 08:44:58 19XX ID: S/N:000000 PBX:00
(Modem enabled) Last Logon : 00/00 00:00
@WAITING FOR VCU READY
SYSTEM INITIALIZATION SUSPENDED!
PASSWORD:
@
At this point the Octel Overture 200/300 has completely booted from
floppy diskette.
Prepare the System
1. Forward ports.
Boot the System
2. Make sure software diskette #1
(for the correct release level) is
write-protected.
3. Insert software diskette #1 (for
the correct release level) into
the floppy drive.
4. Adjust the baud rate of the
terminal/teleprinter to 300, 1200
or 9600 baud.
5. Press the Reload button to boot
from floppy diskette.
6. When prompted, insert disk 2.