Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 46)

1-16 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
7. DISTRIBUTION LISTS.
Enter the LIST NUMBER. (1–16 digits).
This Number must already exist as a mailbox in the USER table.
Then enter each mailbox to be added to the list.(1–16 digits).
If the list exists, new mailboxes will be appended to existing ones.
Enter empty line when done.
Enter DISTRIBUTION LIST NUMBER.
ADD:4000
WARNING: MESSAGES IF ANY IN MAILBOX WILL BE LOST!
ARE YOU SURE (Y/N) ? (Y/N, EMPTY LINE = N):Y
NEW DISTRIBUTION LIST.
Enter each MAILBOX or RANGE to be added to this list.
During INSTALL, you can create system distribution lists and add member addresses. The
distribution list number and member numbers must already exist as a mailbox in the USER Table.
If distribution lists are not being added during INSTALL, press Enter . You can add them later,
through the UPDATE program.
8. COS
COS tables are not configured during the INSTALL program. When INSTALL is complete, enter the
UPDATE program and add attributes to the COS numbers that were defined for each port and
mailbox defined in the USER Table in question 2. Refer to the Configuration volume, COS chapter.
8. COS.
UPDATE if necessary when INSTALL is complete.
9. INFORMATION TABLES
Question 9 lists the INFORMATION Table indexes for either port or mailbox configuration.
9. INFORMATION TABLES.
Enter the INFORMATION TABLE number to be added. (1–255)
Enter empty line when done.
:254
Is TABLE 254 for a PORT/TRUNK? (If NO, it’s for a MAILBOX.)
(Y/N, empty line = N)
:Y
To COPY an existing INFORMATION TABLE, enter the TABLE NUMBER.
(1–255, empty line = NONE)
Define at least one port and one mailbox INFORMATION Table, because a default INFORMATION
Table must be entered for every SCHEDULE Table (Question 10).