Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 231)

Maintenance Commands 6-1
Octel Overture 200/300 Serenade 3.0 PB60014–01
6.1 COMMAND SUMMARY
Maintenance commands for the Octel Overture
t200/300 message server are entered from the @ prompt.
In this chapter, the maintenance commands are divided into five command types:
- List commands
- Clear commands
- Test commands
- System service mode commands
- Miscellaneous commands
The basic command input is listed in BOLD letters, in the left column. The complete command name is in
bold in the right column. In some instances, a modifier and extension might be required to complete the
command string. You must press
Enter following all command strings before the message server
executes the command.
The message server indicates that it is ready to receive information by displaying the @ prompt. For
example, to list the Hardware Error Table, at the
@ prompt, type
L H Enter
List Commands
Use a LIST command to display maintenance tables, such as the Hardware Error Table or Traffic Peg
Count Table, features, and mailbox information. A space is always required between the L (for LIST )
and the letter following. At the @ prompt type
L [ name ] Enter
Command Basic Definition
L CCM LIST CCM (Serenade 3.0)
Displays the current message server utilization for the Client Controlled
Message pool (CCM). This command is used for OctelAccess application
development.
L C LIST CLERR (Serenade 3.0)
Used for OctelAccess troubleshooting. Lists the client error log that shows
errors that are caused by invalid client requests. The error log contains all
relevant information required to isolate the source of the error.
L F LIST FEATURES
Prints the optional packages installed on the Octel Overture 200/300. Lists
the maximum number of ports, drives, SCHEDULE Table entries, and
mailboxes.
L H LIST HARDWARE
Lists the Hardware Error Table.
L HE x LIST HEADER
Lists the status of a message, where x is the message number.