Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 321)

Log Commands — Log, List Trace, Call Detail Record 7-27
Octel Overture 200/300 Serenade 3.0 PB60014–01
- To configure the type/status combinations to be logged, at the @ prompt, type
LOG MF CDR Enter
@LOG MF CDR
Specify Filters to MODIFY:
<”E”nable or ”D”isable>
Empty line when done. ESCape to abort.
>
- The message server prompts you to specify the filters to be modified. If all transaction types and all
status values are to be enabled, at the > prompt, type
E ALL ALL Enter
- You can enter additional modifications to the CDR log. If no other modifications are to be made,
press
Enter again. The message server confirms that the CDR log was modified.
>E ALL ALL
>
LOG FILTERS MODIFIED
- If specific transaction types should be set, at the > prompt, enter the type of transaction and the status
value to set. Refer to Table 7-2 and Table 7-3 for the correct abbreviations to enter, or use the
LOG
PF CDR command to display the CDR log status to view these abbreviations. Refer to the
Displaying CDR Type and Status Configuration section.
- A transaction type and a status value can be partially specified. When only the first letter (or two) is
entered, all types and values beginning with that letter are enabled. In the following example, only
transaction types beginning with
CAL and status values beginning with B were set.
>E CAL B
>
LOG FILTERS MODIFIED
@LOG PF CDR
Specify Filters to PRINT:
<”E”nable or ”D”isable>
Empty line when done. ESCape to abort.
>E C B
CALMBX BUSY BADP BADM BLOK BADU
CALATT BUSY BADP BADM BLOK BADU
CALPA BUSY BADP BADM BLOK BADU
CALFLX BUSY BADP BADM BLOK BADU
CALNXT BUSY BADP BADM BLOK BADU
CALDID BUSY BADP BADM BLOK BADU
CALINT BUSY BADP BADM BLOK BADU
CALEXT BUSY BADP BADM BLOK BADU
CALIMM BUSY BADP BADM BLOK BADU
CALATD BUSY BADP BADM BLOK BADU
CALPAD BUSY BADP BADM BLOK BADU
CALHLP BUSY BADP BADM BLOK BADU
>