Reliant Octel 200 and Octel 300 Message Servers PB6001401 - Manual (Page 434)

9-2 Installation and Maintenance Volume
Octel Overture 200/300 Serenade 3.0 PB60014–01
Power Supply Output
Check voltages using a digital volt meter. Refer to the Installation chapter, Octel Overture 200/300
Hardware Installation section, in this volume.
Preventive Maintenance Tools and Equipment
The tools and equipment required to perform preventive maintenance tasks on the Octel Overture
200/300 are as follows:
- Antistatic wrist strap
- Digital volt/ohm meter
- RS-232C-compatible ASCII send/receive terminal capable of 300, 1200, or 9600 baud. Refer to the
Installation chapter, Terminal Communications section, in this manual.
- Three standard, touch-tone telephones
- Telephone test set (butt set)
- Large, flat-bladed screwdriver
- No. 1 Phillips screwdriver
- IC puller
- Breakout box
- Digit grabber
- Flashlight
Octel Overture 200 Diagrams
Use the following Octel Overture 200 diagrams to provide assistance when performing preventive
maintenance or replacing components. Figure 9-1 shows the Octel Overture 200 shelf structure.
Figure 9-2 through Figure 9-4 illustrate the front, rear, and inside views of the Octel Overture 200 server.