Yokogawa GC8000 Process Gas Chromatograph - Manual (Page 302)

<5. EtherLCD>
5-51
IM 11B08A01-01E
 GCM Method Copy Screen
Press F4 (Copy).
1 1 / 1 1 / 2 2
1 5 : 1 5 : 4 5 GCM Method copy
Source GCM #1 / Method #1
> - Destination GCM number 0
- Destination Method number 0
Menu Main Exec
F1 F2 F3 F4 F5 F6
Figure 5.64 Example of the GCM method copy screen
F1(Menu): Displays Table Menu screen.
F2(Main): Displays GCM Method Setup screen.
F5(Exec): Executes the GCM method copy.
Display Item Name Set Lower Limit Upper Limit Unit Remarks
GCM # Copy source GCM
number
1 6
Method # Copy source method
number
1 6
Copy Target
GCM Number
○ 1 6
Copy Target
Method
Number
○ 1 6
(1) Just prior to navigating to this screen, the number on the GCM Method screen when F4
(Copy) was pressed is displayed as the copy source for GCM number and method number.
(2) Navigating to this screen displays the initial number for the copy target GCM number and
method number are 0.
(3) Selecting the copy target GCM number displays Copy target GCM number: in the second
line on the bottom. The copy target GCM number must be entered here.
(4) Selecting the copy target method number displays Copy target method number: in the
second line on the bottom. The copy target method number must be entered here.
(5) Pressing F5 (Exec) executes the method copy. The GCM number and method number of
the copy target are then displayed again as 0.
TIP
If the SYS numbers of the copy source and the copy target are different, copy cannot be executed.
(6) If the copy fails (If the SYS numbers of the copy source and the copy target are different),
“Copy not executed” is displayed in the second line on the bottom. The GCM method
copy executes both the GCM method and SYS method. For that reason, the copy can be
executed only when the numbers of SYS are equal.
2nd Edition : May 11, 2012-00
5