Yaskawa MEMOCON GL120 - Manual (Page 394)

!
5.2 Installing Mounting Bases and Modules
— 5-37 —
3) Connecting the cable
Caution Make sure that all cable connectors for the Module are securely inserted and tightened.
Insufficient insertion and/or looseness may cause malfunction of the GL120 and GL130.
The following shows the cable connection to the connector type module.
a) Check that the Module is installed on the Module Base.
b) Fit the cable to the Module connector.
c) Tighten the Connector fixing screw on the connector.
4) Removing the cable
The following shows how to remove the connector type module.
a) Loosen the connector fixing screw on the connector.
b) Remove the connector from the Module.
Note When hot swapping, it may cause input signal or output signal chatter when inserting or re-
moving a cable connector to or from the Module. If this is a problem, then setup a chatter
prevention switch for each Module and always turn this switch OFF to cut off the DC power
supply before hot swapping.
5) Removing modules
Use the following procedures to remove the connecting type Module from the Mounting
Base.
Remove the Module from the Mounting Base as shown below.
a) Loosen the Module mounting screw on the Module.
Module mounting screw
(M4, Phillips)
DC24IN-32P
5