Yaskawa MEMOCON GL120 - Manual (Page 346)

System Components: Functions and Specifications
4.8.2 Battery Module cont.
— 4-290 —
2) Connecting the Motion Module
The following outlines typical connection between the battery voltage output connec-
tor (2CN) and the Motion Module.
Battery Module Motion Module
Twisted-pair cable
to
Note Although there is a charge-prevention diode for the lithium battery in the battery voltage out-
put section of the BAT Module to prevent reverse voltage, be very careful to connect the ter-
minals correctly.
3) Procedure for Cable Preparations
Prepare the cables as described next.
a) Remove the covering of the wires for approximately 6.5 mm from the end of the
wires
Core
Covering
6.5 mm
b) Secure the ends of the wires by pressing the core firmly to the back of the plug and
tightening the screws to a tightening torque of between approximately 0.3 and
0.4 Nm.
− side
+ side
4