Yaskawa MEMOCON GL120 - Manual (Page 386)

!
!
5.2 Installing Mounting Bases and Modules
— 5-29 —
c) Remove the Module from the Module hook on the Mounting Base.
Module hook
Module
connector
Mounting Base
PS10
5.2.4 Installing the Terminal Block for Field Connection Module
1) This section shows how to install or remove the following Module.
(1) I/O Module with the terminal block for field connection
(2) Special Purpose Module with the terminal block for field connection
(3) M-NET Module
2) Installing the Module
Caution Do not remove the connector covers from the Module connectors on the Mounting Base slots
where no Modules are installed.
The GL120 and GL130 may malfunction if any foreign matter enters a Module connector.
Caution Make sure that all mounting screws for the Modules are securely tightened.
Make sure that all mounting screws for the Modules are securely tightened so that they
do not become loose. Loose screws may cause malfunction of the GL120 and GL130.
Install the Terminal Block for the Module on the Mounting Base.
Use the following procedures to install the Module.
1) Remove the cover from the Module connector on the Mounting Base.
Module hook
Module connector
5