Yaskawa MEMOCON GL120 - Manual (Page 201)

4.4 Communications Modules
— 4-145 —
(2) Communications parameters:
Baud rate: 9,600 bps
Parity check: Yes
Parity: Even
Stop bits: 1
Data bit length: 8
Delay time:
0 ms
f) When the communications mode and parameters of MEMOBUS port are set to the
user settings, you can set and use any setting from the communications modes and
parameters shown in Table 4.58 on page 4-137. Selection is done using the MEMO-
SOFT.
g) Examples of setting the DIP switch are shown below:
Example 1
When the DIP switch is set as shown in the diagram at the right, the ME-
MOBUS Module (RS-422) is set as follows:
• Communications parameters of port 2 are set to the defaults.
• Communications parameters of port 1 are set to the defaults.
• Port 2 is in MEMOBUS Mode.
• Port 1 is in MEMOBUS Mode.
• Port 2 is slave port.
• Port 1 is slave port.
• Module number: 1
• Normal operation mode
Example 2
When the DIP switch is set as shown in the diagram at the right, the ME-
MOBUS Module (RS-422) is set as follows:
• Communications parameters of port 2 are set to the defaults.
• Communications parameters of port 1 are set to the defaults.
• Port 2 is in transparent mode.
• Port 1 is in transparent mode.
• Port 2 is combined master/slave port.
• Port 1 is combined master/slave port.
• Module number: 2
• Normal operation mode
4
A EXAMPLE "
12
345678
O N
12
345678
O N