Yaskawa MEMOCON GL120 - Manual (Page 142)

System Components: Functions and Specifications
4.3.5 Using CPU Modules 2 (For CPU21) cont.
— 4-86 —
Table 4.29 Settings for ROM Operation
Pin 4 Pin 5 Pin 6 Function
OFF Any Any Does not recognize PC Cards or load ROM operation
files.
ON OFF OFF Reads the ROM operation files, other than those
containing reference data, when the power is turned
ON. The start mode is normal operation.
ON Reads all the ROM operation files when the power is
turned ON. The start mode is normal operation.
ON OFF Reads the ROM operation files, other than those
containing reference data, when the power is turned
ON. The start mode is automatic RUN operation.
ON Reads all the ROM operation files when the power is
turned ON. The start mode is automatic RUN
operation.
Note Be sure to turn OFF DIP switch pin 4 before removing a PC Card from the CPU21 Module. If
the PC Card is removed with DIP switch pin 4 turned ON, the files in the PC Card may be
destroyed.
4. PC Card Slot
A CPU21 Module can be operated from a ladder logic program read from a PC Card when the
Module power is turned ON. The PC Card slot is used for inserting the PC Card.
A. What are PC Cards?
1) PC Cards are IC cards that satisfy the requirements of the PC Card Standard.
This standard is set out in PCMCIA Release 2.1 and JEIDA Version 4.2.
2) There are various types of PC Card, such as RAM cards, EEPROM cards, flash cards,
ATA cards, and LAN cards. Only ATA cards can be used with the GL120 Series PLCs.
B. PC Cards Used By the GL120 Series
1) Phoenix Card Manager Plus, which is the PCMCIA software for PC Cards, is installed in
the P120 Programming Panel.
2) The recommended PC Cards and the PC Cards approved for operation are listed below.
a) Recommended PC Cards
PCMCIA Solid State File Cards Manufactured by IBM:
• IBM17JSSFP3MB 3 MB
• IBM17JSSFP5MB 5 MB
4