Digi NS9750 - Manual (Page 473)

w w w . d i g i e m b e d d e d . c o m 4 4 9
P C I - t o - A H B B r i d g e
Register bit assignment
Bits Access Mnemonic Reset Description
D31 R YV_SKT 0 When set, indicates that VCC=Y.Y volts can be
supplied to the socket.
D30 R XV_SKT 0 When set, indicates that VCC=X.X volts can be
supplied to the socket.
D29 R V3_SKT 0 When set, indicates that VCC=3.3 volts can be
supplied to the socket.
D28 R V5_SKT 0 When set, this bit indicates that VCC=5 volts can be
supplied to the socket.
D27 Hard-wired
to 0 ZV_SUPPORT 0 Zoomed video support
Always set to 0, as NS9750 does not support this bit.
D26:14 Hard-wired
to 0 Reserved N/A N/A
D13 R YV_CARD 0 When set, indicates that the card inserted into the
socket supports
VCC=Y.Y volts.
This bit can also be set by writing a 1 to the
FYV_CARD bit in the CardBus Socket Force Event
register.
D12 R XV_CARD 0 When set, indicates that the card inserted into the
socket supports
VCC=X.X volts.
This bit can also be set by writing a 1 to the
FXV_CARD in the CardBus Socket Fore Event
register.
Table 282: Cardbus Socket Present State register
Reserved
BAD_
VCC_
REQ
DATA_
LOST
NOTA_
CARD
CINT
CB_
CARD
CARD_
16
PWR_
CYC
CCD2 CCD1
CSTS
CHG
13 12 11 10 9 8 7 6 5 4 3 2 1 0 15 14
31 29 28 27 26 25 24 23 22 21 20 19 18 17 16 30
V3_
SKT
V5_
SKT
ZV_
SUPP
YV_
SKT
XV_
SKT
Reserved
YV_
CARD
XV_
CARD
V3_
CARD
V5_
CARD