Dell POWEREDGE M1000E - Manual (Page 701)

Spanning Tree Commands 701
Parameter Description
Default Configuration
The default port-priority for IEEE STP is 128.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
The priority will be set to the nearest multiple of 4096 if not an exact multiple
of 4096.
Example
The following example configures the port priority of gigabit Ethernet
interface 1/0/5 to 144.
console(config)#interface gigabitethernet 1/0/5
console(config-if)#spanning-tree mst 1 port-priority
144
spanning-tree mst priority
Use the spanning-tree mst priority command in Global Configuration mode
to set the switch priority for the specified spanning-tree instance. To return to
the default setting, use the no form of this command.
Syntax
spanning-tree mst instance-id priority priority
no spanning-tree mst instance-id priority
Parameter Description
instance-id ID of the spanning-tree instance. (Range: 1-4094)
priority The port priority. (Range: 0-240 in multiples of 16.)
2CSPC4.XModular-SWUM200.book Page 701 Thursday, March 10, 2011 11:18 AM