Dell POWEREDGE M1000E - Manual (Page 269)

Address Table Commands 269
Syntax
mac address-table static mac-addr vlan vlan-id interface {gigabitethernet |
port-channel | tengigabitethernet} interface-id
no mac address-table static mac-addr vlan vlan-id [interface
{gigabitethernet | port-channel | tengigabitethernet} interface-id]
Syntax Description
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds a permanent static MAC-layer station source
address 3aa2.64b3.a245 to the MAC address table.
console(config)# mac address-table static
3AA2.64B3.A245 vlan 1 interface gigabitethernet 1/0/8
port security
Use the port security command in Interface Configuration mode to disable
the learning of new addresses on an interface. To enable new address learning,
use the no form of the port security command.
Parameter Description
mac-address A valid MAC address in the format xxxx.xxxx.xxxx.
vlan-id Valid VLAN ID (1-4093)
interface-id A valid physical unit/slot/port or port-channel number.
2CSPC4.XModular-SWUM200.book Page 269 Thursday, March 10, 2011 11:18 AM