Dell POWEREDGE M1000E - Manual (Page 131)

Command Groups 131
ip ospf hello-interval Sets the OSPF hello interval for the specified
interface.
IC
ip ospf mtu-ignore Disables OSPF maximum transmission unit
(MTU) mismatch detection.
IC
ip ospf network Configure OSPF to treat an interface as a point-
to-point, rather than broadcast interface.
IC
ip ospf priority Sets the OSPF priority for the specified router
interface.
IC
ip ospf retransmit-
interval
Sets the OSPF retransmit Interval for the
specified interface.
IC
ip ospf transmit-delay Sets the OSPF Transit Delay for the specified
interface.
IC
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSPF
nsf Enables OSPF graceful restart. ROSPF
nsf helper Allow OSPF to act as a helpful neighbor for a
restarting router.
ROSPF
nsf helper strict-lsa-
checking
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
ROSPF
nsf restart-interval Configures the length of the grace period on the
restarting router.
ROSPF
network area Enables OSPFv2 on an interface and sets its area
ID if the IP address of an interface is covered by
this network command.
ROSPF
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSPF
passive-interface (router
mode)
Sets the interface or tunnel as passive. ROSPF
redistribute Configures OSPF protocol to allow redistribution
of routes from the specified source
protocol/routers.
ROSPF
Command Description Mode a
2CSPC4.XModular-SWUM200.book Page 131 Thursday, March 10, 2011 11:18 AM