Dell POWEREDGE M1000E - Manual (Page 490)

490 IPv6 MLD Snooping Commands
interface because it did not receive a report for a particular group in that
interface. This value must be less than the MLD Query Interval time value.
The range is 1 to 3599 seconds.
Syntax
ipv6 mld snooping maxresponse [vlan-id] [seconds]
no ipv6 mld snooping maxresponse [vlan-id]
• vlan_id — Specifies a VLAN ID value in VLAN Database mode.
•
seconds — MLD maximum response time in seconds. (Range: 1–3599)
Default Configuration
The default maximum response time is 10 seconds.
Command Mode
Interface Configuration mode.
VLAN Database mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-4/0/1)#ipv6 mld snooping
maxresponse 33
ipv6 mld snooping mcrtexpiretime
The ipv6 mld snooping mcrtexpiretime command sets the Multicast Router
Present Expiration time. The time is set for a particular interface or VLAN.
This is the amount of time in seconds that a switch waits for a query to be
received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 1 to 3600 seconds.
Syntax
ipv6 mld snooping mcrtexpiretime [ vlan-id ] [ seconds ]
2CSPC4.XModular-SWUM200.book Page 490 Thursday, March 10, 2011 11:18 AM