Dell POWEREDGE M1000E User Manual
Page 110
110
Command Groups
protocol vlan group all
Adds all physical unit/slot/port interfaces to the
protocol-based VLAN identified by
groupid.
GC
show dvlan-tunnel
Displays all interfaces enabled for Double
VLAN Tunneling.
PE
show dvlan-tunnel interface Displays detailed information about Double
VLAN Tunneling for the specified interface.
PE
show interfaces switchport Displays switchport configuration.
PE
show port protocol
Displays the Protocol-Based VLAN information
for either the entire system or for the indicated
group.
PE
show vlan
Displays detailed information, including
interface information and dynamic vlan type,
for a specific VLAN.
PE
show vlan association mac Displays the VLAN associated with a specific
configured MAC address.
PE
show vlan association
subnet
Displays the VLAN associated with a specific
configured IP subnet.
PE
switchport access vlan
Configures the VLAN ID when the interface is
in access mode.
IC
switchport forbidden vlan
Forbids adding specific VLANs to a port.
IC
switchport general
acceptable-frame-type
tagged-only
Discards untagged frames at ingress.
IC
switchport general allowed
vlan
Adds or removes VLANs from a port in General
mode.
IC
switchport general ingress-
filtering disable
Disables port ingress filtering.
IC
switchport general pvid
Configures the PVID when the interface is in
general mode.
IC
switchport mode
Configures the VLAN membership mode of a
port.
IC
switchport trunk
Adds or removes VLANs from a trunk port.
IC
Command
Description
Mode
a
2CSPC4.XModular-SWUM200.book Page 110 Thursday, March 10, 2011 11:18 AM