Dell POWEREDGE M1000E - Manual (Page 947)

IPv6 PIM Commands 947
Example
console(config)#ipv6 pim rp-address
2001:db8:85a3:0:0:8a2e:370:7334 ffe8::0 /16 override
ipv6 pim rp-candidate
Use the ipv6 pim rp-candidate command to configure the router to advertise
itself to the bootstrap router (BSR) as a PIM candidate Rendezvous Point
(RP) for a specific multicast group range. Use the no form of this command
to return to the default configuration.
Syntax
ipv6 pims rp-candidate vlan { vlan-id group-address group-mask }
no ipv6 pims rp-candidate vlan { vlan-id group-address group-mask }
Parameter Description
Default Configuration
None - The router does not advertise itself as an RP candidate by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim rp-candidate vlan 10
ffe8::0/16
Parameter Description
vlan-id A valid VLAN identifier with multicast routing enabled.
group-address A valid Multicast group address.
group-mask A mask indicating the range of multicast groups for which the
router should advertise itself as an RP-candidate.
2CSPC4.XModular-SWUM200.book Page 947 Thursday, March 10, 2011 11:18 AM