Dell POWEREDGE M1000E - Manual (Page 1231)

Tunnel Interface Commands 1231
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Examples
The following examples show the parameters related to an individual tunnel
and to all tunnel interfaces.
console#show interfaces tunnel 1
Interface Link Status.......................... down
MTU size....................................... 1480 bytes
console#show interfaces tunnel
TunnelId Interface TunnelMode SourceAddress DestinationAddress
-------- --------- ---------- ------------- ----------------
1 tunnel 1 IPv6OVER4 10.254.25.14 10.254.25.10
2 tunnel 2 IPv6OVER4 10.254.20.10
tunnel destination
Use the tunnel destination command in Interface Configuration mode to
specify the destination transport address of the tunnel.
Syntax
tunnel destination ip-address
no tunnel destination
• ip-addr ess — Valid IPv4 address.
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 1231 Thursday, March 10, 2011 11:18 AM