Dell POWEREDGE M1000E - Manual (Page 831)

DHCP Server and Relay Agent Commands 831
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
IP DHCP Pool Configuration mode
next-server
Use the next-server command in DHCP Pool Configuration mode to set the
IPv4 address of the TFTP server to be used during auto-install. Use the no
form of the command to remove the next server configuration.
Syntax
next-server ip-address
no next-server
Parameter Description
Default Configuration
There is no default IPv4 next server configured.
Command Mode
DHCP Pool Configuration mode
Parameter Description
network-number A valid IPv4 address
mask A valid IPv4 network mask with contiguous left-aligned bits.
prefix-length An integer indicating the number of leftmost bits in the
network-number to use as a prefix for allocating cells.
Parameter Description
ip-address The IPv4 address of the TFTP server to use during auto-
configuration.
2CSPC4.XModular-SWUM200.book Page 831 Thursday, March 10, 2011 11:18 AM