Dell POWEREDGE M1000E - Manual (Page 852)

852 DHCPv6 Commands
FILE LOCATION: C:\My Documents\ActiveProjects\2CSPC7000-SWUM400 Dell Zeiss CLI
Guide\working\DHCPv6.fm
D E L L C O NF I D E N TI A L – P R EL I M I N A RY 3/ 1 0 / 1 1 - F O R P R O O F O N LY
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC and User EXEC modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the configured DHCP pool based on the
entered IPv6 address.
console#show ipv6 dhcp binding 2020:1::
show ipv6 dhcp interface (User EXEC)
Use the show ipv6 dhcp interface command in User EXEC mode to display
DHCPv6 information for all relevant interfaces or for the specified interface.
If an interface is specified, the optional statistics parameter is available to
view statistics for the specified interface.
Syntax
show ipv6 dhcp interface [type number] [statistics ]
Syntax Description
Default Configuration
This command has no default configuration.
Parameter Description
type number Tunnel tunnel-id (Range: 0-7)
or
VLAN vlan-id (Valid VLAN id)
statistics Enables statistics display if interface is specified.
2CSPC4.XModular-SWUM200.book Page 852 Thursday, March 10, 2011 11:18 AM