Dell POWEREDGE M1000E - Manual (Page 954)

954 IPv6 PIM Commands
None of the routing interfaces are enabled for PIM
show ipv6 pim neighbor
Use the show ipv6 pim neighbor command to display IPv6 PIM neighbors
discovered by PIMv2 Hello messages. If the interface number is not specified,
this command displays the neighbors discovered on all the PIM-enabled
interfaces.
Syntax
show ipv6 pim neighbor [vlan vlan-id ]
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
There are no user guidelines for this command. Field descriptions are shown
in the table below.
Example
(console) # show ipv6 pim neighbor vlan 10
Parameter Description
vlan-id A valid VLAN ID for which multicast routing has been enabled.
Field Description
Neighbor Addr IPv6 address of the PIM neighbor
Interface Interface number
Uptime Time since the neighbor was learned
Expiry Time Time remaining for the neighbor to expire
2CSPC4.XModular-SWUM200.book Page 954 Thursday, March 10, 2011 11:18 AM