Dell POWEREDGE M1000E - Manual (Page 267)

Address Table Commands 267
User Guidelines
If routers exist on the VLAN, do not change the unregistered multicast
addresses state to drop on the routers ports.
NOTE: Do not use the mac address-table multicast forbidden forward-unregistered
command with the mac address-table multicast forward-unregistered command on
the same interface.
Example
The following example displays how to enable forwarding of unregistered
multicast addresses.
console(config)#bridge multicast forward-unregistered
vlan 1
mac address-table multicast static
Use the mac address-table multicast static command in Global
Configuration mode to register MAC layer Multicast addresses to the bridge
table and to add ports to the group statically. To deregister the MAC address,
use the no form of the mac address-table multicast static command.
Syntax
mac address-table multicast static vlan vlan-id { mac-multicast-address | ip-
multicast-address } [add | remove] [interface {gigabitethernet | port-
channel | tengigabitethernet} interface-list ]
no mac address-table multicast static vlan
Parameter Description
Parameter Description
add Adds ports to the group. If no option is specified, this is the
default option.
remove Removes ports from the group.
vlan vlan-id Valid vlan ID (1-4093).
mac-multicast-
address
MAC multicast address in the format xxxx.xxxx.xxxx.
2CSPC4.XModular-SWUM200.book Page 267 Thursday, March 10, 2011 11:18 AM