Dell POWEREDGE M1000E - Manual (Page 1600)

1596 Telnet Server Commands
Parameter Ranges
Not applicable
Command Mode
Global Configuration
Usage Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable
ip telnet port
The ip telnet port command is used to configure the Telnet service port
number on the switch.
Syntax
ip telnet port port number
• port number — Telnet service port number (Range: 1–65535)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
Usage Guidelines
No specific guidelines.
2CSPC4.XModular-SWUM200.book Page 1596 Thursday, March 10, 2011 11:18 AM