Dell POWEREDGE M1000E - Manual (Page 1232)

1232 Tunnel Interface Commands
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the destination transport address of tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel destination
10.1.1.1
tunnel mode ipv6ip
Use the tunnel mode ipv6ip command in Interface Configuration mode to
specify the mode of the tunnel.
Syntax
tunnel mode ipv6ip [6to4]
no tunnel mode
• 6to4 — Sets the tunnel mode to automatic.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies ipv6ip mode for tunnel 1.
2CSPC4.XModular-SWUM200.book Page 1232 Thursday, March 10, 2011 11:18 AM