Default configuration, Command mode, User guidelines – Dell POWEREDGE M1000E User Manual

Page 312: Example, Dhcp l2relay (interface configuration), Syntax

312

DHCP Layer 2 Relay Commands

Default Configuration

DHCP L2 Relay is disabled by default.

Command Mode

Global Configuration.

User Guidelines

There are no user guidelines for this command.

Example

console(config)#dhcp l2relay

dhcp l2relay (Interface Configuration)

Use the dhcp l2relay command to enable DHCP L2 Relay for an interface.

Use the "no" form of this command to disable DHCP L2 Relay for an

interface.

Syntax

dhcp l2relay
no dhcp l2relay

Default Configuration

DHCP L2Relay is disabled on all interfaces by default.

Command Mode

Interface Configuration (Ethernet, Port-channel).

User Guidelines

There are no user guidelines for this command.

Example

console(config-if-1/0/1)#dhcp l2relay

2CSPC4.XModular-SWUM200.book Page 312 Thursday, March 10, 2011 11:18 AM