Dell POWEREDGE M1000E - Manual (Page 759)

Voice VLAN Commands 759
Parameter Description
Default Configuration
The default DSCP value is 46.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-Gi1/0/1)#voice vlan 1
console(config-if-Gi1/0/1)#voice vlan dot1p 1
console(config-if-Gi1/0/1)#voice vlan none
Parameter Description
auth Enables/disables authentication on the voice vlan port.
data Observe the priority on received voice vlan traffic (trusted
mode).
dot1p Configure Voice VLAN 802.1p priority tagging for voice traffic.
dscp Configure DSCP value for voice traffic on the voice vlan port.
(Range: 0–64).
none Allow the IP phone to use its own configuration to send
untagged voice traffic.
priority The Dot1p priority for the voice VLAN on the port.
trust Trust the dot1p priority or DSCP values contained in packets
arriving on the voice vlan port.
untagged Configure the phone to send untagged voice traffic.
untrust Do not trust the dot1p priority or DSCP values contained in
packets arriving on the voice vlan port.
vlanid The voice VLAN ID.
2CSPC4.XModular-SWUM200.book Page 759 Thursday, March 10, 2011 11:18 AM