Dell POWEREDGE M1000E - Manual (Page 1043)

Multicast Commands 1043
Designated Router 192.168.10.1
If none of the interfaces are enabled for PIM, the following message is
displayed:
None of the routing interfaces are enabled for PIM
show ip pim neighbor
Use the show ip pim neighbor command in User EXEC or Privileged EXEC
modes to display PIM neighbors discovered by PIMv2 Hello messages. If the
interface number is not specified, this command displays the neighbors
discovered on all the PIM-enabled interfaces.
Syntax
show ip pim neighbor [ vlan vlan-id ]
• vlan-id — A valid VLAN ID for which multicast routing has been enabled.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
This command has no user guidelines.
Field Descriptions
Field Description
Neighbor Addr IP address of the PIM neighbor
Interface Interface number
Uptime Time since the neighbor is learned
Expiry Time Time remaining for the neighbor to expire
2CSPC4.XModular-SWUM200.book Page 1043 Thursday, March 10, 2011 11:18 AM