Dell POWEREDGE M1000E - Manual (Page 625)

QoS Commands 625
Example
The following example displays adding a match condition based on the "ip"
protocol name keyword.
console(config-classmap)#match protocol ip
match source-address mac
Use the match source-address mac command in Class-Map Configuration
mode to add to the specified class definition a match condition based on the
source MAC address of the packet.
Syntax
match source-address mac address macmask
• macaddr — Specifies any valid layer 2 MAC address formatted as six two-
digit hexadecimal numbers separated by colons.
• macmask — Specifies a layer 2 MAC address bit mask formatted as six
two-digit hexadecimal numbers separated by colons. This bit mask does
not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds to the specified class definition a match
condition based on the source MAC address of the packet.
console(config-classmap)# match source-address mac
10:10:10:10:10:10 11:11:11:11:11:11
2CSPC4.XModular-SWUM200.book Page 625 Thursday, March 10, 2011 11:18 AM