Dell POWEREDGE M1000E - Manual (Page 635)

QoS Commands 635
Class Name..................................... ipv4
Class Type..................................... All
Class Layer3 Protocol.......................... ipv4
Match Criteria Values
---------------------------- -------------------------------------
Source IP Address 2.2.2.2 (255.255.255.0)
console#show class-map stop_http_class
Class Name..................................... stop_http_class
Class Type..................................... All
Class Layer3 Protocol.......................... ipv6
Match Criteria Values
---------------------------- -------------------------------------
Source IP Address 2001:DB8::/32
Source Layer 4 Port 80(http/www)
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command in Privileged EXEC
mode to display the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [{gigabitethernet unit/slot/port | port-
channel port-channel-number | tengigabitethernet unit/slot/port }]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
2CSPC4.XModular-SWUM200.book Page 635 Thursday, March 10, 2011 11:18 AM