Dell POWEREDGE M1000E - Manual (Page 554)

554 Multicast VLAN Registration Commands
mvr vlan
Use the mvr vlan command in Global Config mode to set the MVR multicast
VLAN. Use the no form of the command to set the MVR multicast VLAN to
the default value.
Syntax
mvr vlan 1–4094
no mvr vlan
Parameter Description
Default Configuration
The default value is 1.
Command Mode
Global Config
User Guidelines
The following table lists the completion messages.
mvr immediate
Use the mvr immediate command in Interface Config mode to enable MVR
Immediate Leave mode. Use the no form of this command to set the MVR
multicast VLAN to the default value.
Parameter Description
vlan The VLAN specifies the port on which multicast data is
expected to be received. Source ports should belong to this
VLAN.
Message Type Message Description
Successful Completion Message MVR multicast VLAN ID is set to the
default value which is equal to 1.
Error Completion Message Receiver port in mVLAN, operation failed.
2CSPC4.XModular-SWUM200.book Page 554 Thursday, March 10, 2011 11:18 AM