Dell POWEREDGE M1000E - Manual (Page 185)

Using the CLI 185
Starting the CLI
To begin running the CLI, perform the following steps:
NOTE: This procedure is for use on the console line only.
NOTE: The Easy Setup Wizard is available only when the system is in default state
with no user configuration saved previously.
1 Start the switch and wait until the startup procedure is complete and the
User EXEC mode is entered. The prompt console> is displayed.
2 Configure the switch using the Easy Setup Wizard and enter the necessary
commands to complete the required tasks.
3 When finished, exit the session with the quit or exit command.
The switch can be managed over a direct connection to the switch console
port or through a Telnet connection. If access is through a Telnet connection,
the switch must have a defined IP address, corresponding management access
granted, and a connection to the network.
Tunnel From Global
Configuration
mode, use the
interface tunnel
command. Or, use
the abbreviation
interface tu.
console(config-tunnel tunnel-
id )#
To exit to Global
Configuration
mode, use the
exit command,
or press
+
to Privileged
EXEC mode.
Loopback From Global
configuration mode,
use the interface
loopback
command. Or, use
the abbreviation
interface lo.
console(config-
loopback
loopback-id )#
To exit to Global
Configuration
mode, use the
exit command,
or press
+
to Privileged
EXEC mode.
Command Mode Access Method Command Prompt Exit or Access
Previous Mode
2CSPC4.XModular-SWUM200.book Page 185 Thursday, March 10, 2011 11:18 AM