Dell POWEREDGE M1000E - Manual (Page 760)

760 Voice VLAN Commands
console(config-if-Gi1/0/1)#voice vlan untagged
voice vlan data priority
This command is to either trust or not trust (untrust) the data traffic arriving
on the voice VLAN port.
Syntax
voice vlan data priority { trust | untrust }
• trust — Trust the dot1p priority or DSCP values contained in packets
arriving on the voice vlan port.
• untrust — Do not trust the dot1p priority or DSCP values contained in
packets arriving on the voice vlan port.
Command Mode
Interface Configuration
Default Value
trust
Example
console(config-if-1/0/1)#voice vlan data priority untrust
console(config-if-1/0/1)#voice vlan data priority trust
show voice vlan
show voice vlan [interface {gigabitethernet unit/slot/port |
tengigabitethernet unit/slot/port | all}]
Syntax
When the interface parameter is not specified, only the global mode of the
voice VLAN is displayed.
When the
interface parameter is specified, the following is displayed:
2CSPC4.XModular-SWUM200.book Page 760 Thursday, March 10, 2011 11:18 AM