Dell POWEREDGE M1000E - Manual (Page 556)

556 Multicast VLAN Registration Commands
Syntax
mvr type { receiver | source }
no mvr type
Parameter Description
Default Configuration
The default value is None.
Command Mode
Interface Config
User Guidelines
The following table lists the completion messages.
Example
console(config)#mvr
console(config)#mvr group 239.1.1.1
console(config)#exit
console(config)#interface Gi1/0/1
console(config-if-Gi1/0/1)#switchport access vlan 10
console(config-if-Gi1/0/1)#mvr
console(config-if-Gi1/0/1)#mvr type receiver
Parameter Description
receiver Configure the port as a receiver port. Receiver ports are ports
over which multicast data will be sent but not received.
source Configure the port as a source port. Source ports are ports over
which multicast data is received or sent.
Message Type Message Description
Successful Completion Message None
Error Completion Message • Port is a Trunk port, operation failed.
• Receiver port in mVLAN, operation failed.
2CSPC4.XModular-SWUM200.book Page 556 Thursday, March 10, 2011 11:18 AM