Dell POWEREDGE M1000E - Manual (Page 1096)

1096 OSPF Commands
User Guidelines
This command has no user guidelines.
Example
The following example sets the exit overflow interval for OSPF at 10 seconds.
console(config-router)#exit-overflow-interval 10
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPF Configuration mode
to configure the external LSDB limit for OSPF. If the value is -1, then there is
no limit. When the number of non-default AS-external-LSAs in a router's
link-state database reaches the external LSDB limit, the router enters
overflow state. The router never holds more than the external LSDB limit
non-default AS-external-LSAs in it database. Use the no form of the
command to return the limit to the default value.
Syntax
external-lsdb-limit integer
no external-lsdb-limit
• integer — Maximum number of non-default AS-external-LSAs allowed in
the router's link-state database. (Range: –1 to 2147483647)
Default Configuration
-1 is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
The external LSDB limit MUST be set identically in all routers attached to
the OSPF backbone and/or any regular OSPF area.
2CSPC4.XModular-SWUM200.book Page 1096 Thursday, March 10, 2011 11:18 AM