Dell POWEREDGE M1000E - Manual (Page 1072)

1072 OSPF Commands
console(config-router)#area 20 nssa default-info-
originate metric 250 metric-type 2 no-summary
area nssa default-info-originate
Use the area nssa default-info-originate command in Router OSPF
Configuration mode to configure the metric value and type for the default
route advertised into the NSSA. The metric type can be comparable (nssa-
external 1) or non-comparable (nssa-external 2). Use the no form of the
command to return the metric value and type to the default value.
Syntax
area area-id nssa default-info-originate [ integer ] [ comparable | non-
comparable ]
no area
area-id nssa default-info-originate
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
• integer — Specifies the metric of the default route advertised to the
NSSA. (Range: 1–16777214)
• comparable — A metric type of nssa-external 1
•
non-comparable — A metric type of nssa-external 2
Default Configuration
If no metric is defined, 10 is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the metric value and type for the default
route advertised into the NSSA.
2CSPC4.XModular-SWUM200.book Page 1072 Thursday, March 10, 2011 11:18 AM