Dell POWEREDGE M1000E - Manual (Page 561)

Multicast VLAN Registration Commands 561
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE 1/0/1, 1/0/2, 1/0/3
console#show mvr members 224.1.1.1
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE 1/0/1, 1/0/2, 1/0/3
show mvr interface
Use the show mvr interface command in Privileged EXEC mode to display
the MVR enabled interfaces configuration.
Syntax
show mvr interface [ interface-id [members [vlan vid ]] ]
Parameter Description
The following table explains the output parameters.
Parameter Description
Interface-id Identifies a specific interface.
VID VLAN identifier.
Parameter Description
Port Interface number
Type The MVR port type. It can be None,
Receiver, or Source type.
Status The interface status. It consists of two
characteristics:
1 active or inactive indicating if port is
forwarding.
2 inVLAN or notInVLAN indicating if the
port is part of any VLAN
2CSPC4.XModular-SWUM200.book Page 561 Thursday, March 10, 2011 11:18 AM