Dell POWEREDGE M1000E - Manual (Page 966)

966 IPv6 Routing Commands
no ipv6 mld last-member-query-count
• last-member-query-count — Query count (Range: 1–20).
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-
count 5
ipv6 mld last-member-query-interval
The ipv6 mld last-member-query-interval command sets the last member
query interval for the MLD interface, which is the value of the maximum
response time parameter in the group-specific queries sent out of this
interface. Use the “no” form of this command to set the last member query
interval to the default.
Syntax
ipv6 mld last-member-query-interval last-member-query-interval
no ipv6 mld last-member-query-interval
• last-member-query-interval — The last member query interval (Range:
0–65535 milliseconds).
Default Configuration
The default last member query interval is 1 second.
Command Mode
Interface Configuration (VLAN) mode.
2CSPC4.XModular-SWUM200.book Page 966 Thursday, March 10, 2011 11:18 AM