Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 401)

App-32
IM 04L31A01-01E
#4 PID parameters
Parameter Initial Value
PID parameters > Loop number 1
PID parameters > PID Number 1
PID parameters > Target setpoint –200.0
PID parameters > Proportional band(P) 5.0%
PID parameters > Integral time(I) 240 s
PID parameters > Derivative time(D) 60 s
PID parameters > Output lower limit 0.0%
PID parameters > Output upper limit 100.0%
PID parameters > Shutdown Off
PID parameters > Manual reset 50.0%
PID parameters > Reverse/Direct Reverse
PID parameters > Preset output 0.0%
#5 Control group setting
Parameter Initial Value
Control group > Group number 1
Control group > Group name CONTROL GROUP1
Control group > 1 to 6 > ON/OFF On
Control group > 1 to 6 > Kind Int-Loop
Control group > 1 to 6 > Number 01-06
#6 Ten-segment linearizer I/O
Parameter Initial Value
Ten-segment linearizer I/O > Loop number 1
Ten-segment linearizer I/O > Input type PV1
Ten-segment linearizer I/O > Mode Off
#7 Program control related (only when program control is ON)
<#1 Program parameter setting>
Parameter Initial Value
#1 Pattern initial setting
Program initial setting > Pattern number
1
Program initial setting > Segments 0
Program initial setting > Segment setting method Time
Program initial setting > Pattern name Pattern 1
Program initial setting > Action loop Off
Appendix 6 Initial Values