Yokogawa ADMAG AXR User Manual
Yokogawa Sensors
Table of contents
Document Outline
- Contents
- 1. INTRODUCTION
- 2. HANDLING PRECAUTIONS
- 3. INSTALLATION
- 4. WIRING
- 5. BASIC OPERATING PROCEDURES (USING THE DISPLAY UNIT)
- 6. PARAMETER DESCRIPTION
- 7. OPERATION VIA BRAIN TERMINAL (BT200)
- 8. OPERATION VIA HART CONFIGURATION TOOL (HART 5)
- 8.1 HART Protocol Revision
- 8.2 Device Description (DD) ona HART Configuration Tooland AXR Device Revision
- 8.3 Interconnection between AXR and HART Configuration Tool
- 8.4 Basic Setup
- 8.5 Parameters Configuration
- 8.6 Data Renewing
- 8.7 Self-diagnostic Functions
- 8.8 HART Specific Functions
- 8.9 Menu Tree for DD (HART 5)
- 8.10 Menu Tree for DTM (HART 5)
- 9. OPERATION VIA HART CONFIGURATION TOOL (HART 7)
- 9.1 HART Protocol Revision
- 9.2 Device Description (DD) ona HART Configuration Tooland AXR Device Revision
- 9.3 Interconnection between AXR and HART Configuration Tool
- 9.4 Basic Setup
- 9.5 Parameters Configuration
- 9.6 Data Renewing
- 9.7 Self-diagnostic Functions
- 9.8 HART Specific Functions
- 9.9 Menu Tree for DD and DTM (HART 7)
- 10. ACTUAL OPERATION
- 11. MAINTENANCE
- 12. OUTLINE
- 13. PED (PRESSURE EQUIPMENT DIRECTIVE)
- 14. EXPLOSION PROTECTED TYPEINSTRUMENT
- Appendix 1. Safety Instrumented SystemsInstallation
- INSTALLATION AND OPERATING PRECAUTIONSFOR TIIS FLAMEPROOF EQUIPMENT
- Apparatus Certified Under Technical Criteria(IEC-compatible Standards)
- 1. General
- 2. Electrical Apparatus ofFlameproof Type of Explosion-Protected Construction
- 3. Terminology
- 4. Installation of FlameproofApparatus
- 5. External Wiring forFlameproof Apparatus
- 6. Maintenance of FlameproofApparatus
- 7. Selection of Cable EntryDevices for Flameproof Type
- Revision Information