Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 258)

8-1
IM 04L31A01-01E
Operations for Changing the Displayed Contents
8
Chapter 8 Operations for Changing the Displayed Contents
8.1 Using the Information Display (Alarm
Summary, Message Summary, Memory
Summary, and Control Summary)
This section explains the operations that you can perform when displaying various information
such as alarm summary, message summary, memory summary, and control summary.
Procedure
Switching Displayed Information
1. Press the DISP/ENTER key to show the display selection menu.
2. Select [INFORMATION] using the up and down arrow keys .
3. Press the right arrow key to display the sub menu.
4. Select the desired item using the up and down arrow keys .
5. Press the DISP/ENTER key to show the display for the selected item.
Switching to the Historical Trend
1. Select the item for displaying the historical trend (alarm, message, etc.) using the
up and down arrow keys .
2. Press the DISP/ENTER key to show the display selection menu.
3. Press the right arrow key to display the sub menu.
4. Select [JUMP TO HISTORY] using the up and down arrow keys .
5. Press the DISP/ENTER key to show the historical trend.
To close the menu without switching the display, press the ESC key.
Switching the Alarm Summary Display to Control Alarms Only
Perform the following operation with the alarm summary display showing.
1. Press the
DISP/ENTER key to show the display selection menu.
2. Select [INFORMATION] using the up and down arrow keys and press the right
arrow key to display the sub menu.
3. Select [ALARM (CONTROL)] using the down arrow key .
To set the alarm back to the original display (displaying measurement and control
alarms), select [ALARM(ALL)] by performing the procedures above.