Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 252)

7-6
IM 04L31A01-01E
7.2 Settings Related to Measurement Alarms
This section explains how to set alarm-related parameters such as alarm output ON/
OFF, alarm output type, and alarm delay, and how to clear the alarms when they occur.
Procedure
Opening the Setting Display
• When setting the alarm output
Alarm settings cannot be entered on 0 measurement channel models. An error
message will appear if the range or alarm setting screen is selected.
Press the keys in the following sequence:
MENU key (switch to the Setting mode (Control)) > MENU key (switch to the Set
mode) > #1 soft key (select [Range,Alarm])
The following display appears.
• When setting the alarm delay
The alarm delay setting cannot be entered on 0 measurement channel models (the
setting menu is not displayed).
Press the keys in the following sequence:
MENU key (switch to the Setting mode (Control)) > MENU key (switch to the Set
mode) > #2 soft key (select [Tag, Moving average, Alarm delay])
The following display appears.