Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 213)

5-4
IM 04L31A01-01E
5.3 Program parameter setting > Wait action
setting
This section explains the procedures for setting the wait action during program control.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #1 soft key (select [Program parameter setting])> #2 soft key
(select [Wait action setting])
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Setup Items
Wait action setting
• Wait zone Off/On
Turn ON/OFF the wait zone for each loop. Only the loops that are set as follows are
displayed: [Control] > [#1 Control action, Input setting] > [Control mode] to a mode
other than [Off] and [Program control] to [On] and [Setting mode (Control)] > [#7
Program control parameters] > [#1 Program parameter setting] > [Pattern initial setting
] > [Action loop] to [On]. During cascade control, even-numbered loops within the
same terminal block are not displayed.
• Wait zone values
Set the wait zones for 6 (number of loops) × 5 (number of zones) in the range of “EUS
(0.0 to 100.0%)” of the measurement span. The values can be copied and pasted using
soft keys. The loops that are displayed are the same as those for [Wait zone Off/On]
• Wait time
Set the wait time in [hh:mm:ss] format (selectable range: [00:00:00] to [99:59:59]) for
all the available zones. The setting applies to the same zones in each loop. The
values can be copied and pasted using soft keys. The entry box does not appear if
the wait zones of all loops are set to OFF.