Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 220)

5-11
IM 04L31A01-01E
Program Control Related Setup Operations
5
5.8 Program parameter setting > Repeat action
setting
This section explains the procedures for setting the repeat function during program
control.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #1 soft key (select [Program parameter setting])> #7 soft key
(select [Repeat action setting])
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Setup Items
Repeat action setting
• Pattern number
Displays the pattern number selected in the pattern initial settings.
• Repeat action
Select the repeat function from [Off], [On], and [Repeat].
• Repeat frequency
Set the number of repetitions when the repeat function is turned ON in the range of [1]
to [999].
• Repeat start segment/Repeat end segment
Set the repeat start segment number and the repeat end segment number when the
repeat function is turned ON or when repeating in the range of “1 to 99.” However,
the selectable range for the maximum value is the value specified for [#1 Pattern initial
setting] > [Segments]. Set repeat start segment ≤ repeat end segment.