Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 210)

5-1
IM 04L31A01-01E
Program Control Related Setup Operations
5
Chapter 5 Program Control Related Setup Operations
5.1 Program Control Related Setup Operations
To set up program control, follow the flow chart shown below.
#1
END
END
DISP/ENTER key
#1
DISP/ENTER key
ESC key* 2
#7
ESC key
Select pattern number and
then change the settings.
ESC key
DISP/ENTER
key
#2 to #7 ESC key
Change the settings on setting screens
#2 to #7.
For [#7 Program-control parameters] to appear, you
must set [Control] > [#1 Control action, Input setting] >
[Control mode] to a mode other than [Off] and
[Program control] to [On]. For details on the
procedure, see section 4.1, "Control > Control action."
#1 Pattern initial setting
MENU key (switch to the setting mode (control)) > [Next 1/2] soft key
#1* 1
1
2
3
4
5 6
7
8
ESC key* 2
1 8
1 8
To set a single pattern, carry out steps
to . To set multiple patterns,
repeat steps to .
* 1 If you set pattern parameters of other numbers
after this step, all settings up to that point are
cleared.
* 2 If you did not change the settings on the Pattern
initial setting screen
Note
You cannot carry out setup related to program control that is explained in this chapter when
communication command “FE4” (Output setup data file) is being executed.