Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 217)

5-8
IM 04L31A01-01E
5.6 Program parameter setting > Event setting
This section explains the procedures for setting the events during program control.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #1 soft key (select [Program parameter setting])> #5 soft
key (select [Event setting])
Move to the program pattern setting display
Increment/Decrement the segment number
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Setup Items
Event setting
• Pattern number
Displays the pattern number selected in the pattern initial settings.
• Segment number
Set the segment number [1] to [99] to which the event is to be assigned.
• Event kind
Select the type of event to be assigned, [PVEvent] or [TimeEvent].
• 1 to 16
The time event or PV event number. The number of time events and PV events that
can be set per segment is 16 each.